Entry/exit delays, Entry delay, Exit delay – Panasonic K10059 Manuel d'utilisation

Page 6: Exit alarms

Advertising
background image

6

Entry/Exit Delays

Entry Delay

You can have time to re-enter your house from pre-selected door by programming
entry delay times. You must disarm the system before entry delay time expires. The
phone beeps until you disarm the system.
Confirm with your installer for your delay time.

Exit Delay

You can have time to go out through the exit door without cancelling an alarm. The
exit delay time starts immediately after you arm the system. The phone displays
“You may exit now”. After the message disappears, the system completes
arming and the phone alarms. If programmed, the phone beeps slowly after arming
the system, then beeps fast to alert you of the exit delay time end.
If you do not exit your house, you should disarm the system to stop an alarm and
rearm the system.
Confirm with your installer for your programmed exit delay time.

Exit Alarms

The exit delay starts after you arm the system. If the exit/entry door or interior zone
is faulted after the exit delay time expires, the phone alarms and the entry delay
starts. When you disarm the system before the entry delay time expires, an alarm
stops and the “Alarm Cancelled” and the faulted zone number are displayed.
The message is not sent to the Customer Monitoring Center. Then you can close
the displayed open zone and clear the message by entering your security code.
If the system is not disarmed, or the exit/entry door or interior zone is open before
the entry delay ends, the phone alarms and the exit alarm message and faulted
zone are displayed.
The exit alarm message is sent to the Customer Monitoring Center. You should
disarm the system to stop an alarm, and enter your security code and [1] on the
keypad to clear the display.

SecurityPhone.book 6 ページ 2004年7月21日 水曜日 午後6時58分

Advertising