Bypass, Bypassing protection zones, Quick bypass – Panasonic K10059 Manuel d'utilisation

Page 16

Advertising
background image

Bypassing Protection Zones

16

Quick Bypass

If the Quick Bypass is programmed by the security system installer, you can set all
faulted (open) zones unprotected at once. Confirm with your installer if the Quick
Bypass is active for your system.

When Quick Bypass is used, all faulted (open) zones are unprotected, the alarm
does not sound, and an alarm signal is not sent to the Customer Monitoring Center.
Refer to “Quick Bypass” on page 21 in the 3000EN Security Systems User’s Guide.

Make sure all perimeter doors and windows are closed and

is

displayed.

: Press the soft key (

), and follow steps 2 to 4 above, using

the cordless handset. Press [OFF] to go to the standby mode.

1

Press [ADT].

2

Scroll to “BYPASS” by pressing [d] or [B], then

press [g].

3

Scroll to “QUICK BYPASS” by pressing [d] or

[B], then press [g].

4

Enter your security code.

• If you entered the wrong security code, the phone

will go back to the previous display. Try again from
step 3.

• In a few seconds, all faulted (open) zones are

displayed and automatically bypassed.

• The “Bypass” message is displayed momentarily.

5

Press [STOP] to go to the standby mode.

READY

Base Unit

BYPASS

g

QUICK BYPASS

g

ENTER CODE

----

Handset

ADT

SecurityPhone.book 16 ページ 2004年7月21日 水曜日 午後6時58分

Advertising