Testing the system, Test, Base unit – Panasonic K10059 Manuel d'utilisation

Page 39: Handset

Advertising
background image

39

Testing the System

You can check the system for proper operation. Before testing the system, you
must disarm the security mode and close all protected windows, doors, etc.

Refer to “Testing the System (To Be Conducted Weekly)” on pages 39 to 40 in the
3000EN Security Systems User’s Guide
.

Make sure all perimeter doors and windows are closed and

is

displayed.

: Press the soft key (

), and follow steps 2 to 6 above, using

the cordless handset. Press [OFF] to go to the standby mode.

1

Press [ADT].

2

Scroll to “TEST” by pressing [d] or [B], then

press [g].

3

Enter your security code.

• If you entered the wrong security code, the phone

will go back to the previous display. Try again from
step 2.

4

Press [0].

• “1=Dial” is intended for the installer.
• To remind you that the system is in the test mode,

a beep sounds at regular intervals.

• When the door or window is closed, the display

clears.

5

Open each protected door or window, listen to
the chime and confirm the zone number/zone
description on the display.

6

To exit the Test mode, press [g] while

=Abort Test

” is displayed, then enter your

security code.

7

Press [STOP] to go to the standby mode.

READY

Base Unit

TEST

g

ENTER CODE

----

1=Dial, 0=Walk

Example

Test In Progress

=Abort Test

g

g

ENTER CODE

----

Handset

ADT

SecurityPhone.book 39 ページ 2004年7月21日 水曜日 午後6時58分

Advertising