Pioneer AVD-W6210 - Manuel (Page 37)

36
ENGLISH
ESPAÑOL
DEUTSCH
FRANÇAIS
ITALIANO
NEDERLANDS
6. Fasten the mounting base onto
the dashboard with the tapping
screws.
CAUTION
• Before drilling any mounting
holes, confirm that the screws
will not interfere with any of the
vehicle’s operating systems (such
as the fuel line, brake lines, elec-
trical wiring, etc.).
7. Adjust the display vertical posi-
tion and display angle.
In order to stabilize the display, adjust
the display vertical position so that the
bottom of the display base contacts the
dashboard. Adjust the display to a
good angle for viewing.
Note:
• After you have adjusted the display vertical
position and angle, turn the hidden screw and
the knob clockwise to fasten the display in
place.
If you loosen the hidden screw
with the supplied hexagonal
wrench, you can adjust the
vertical position of the display.
(Refer to the step 3
on page 34.)
If you turn this knob to the left, you
can adjust the angle of the display.
Dashboard
Tapping screws
(3
× 12 mm)
Dashboard