Lexmark X642e MFP - Manuel (Page 93)

93
Status messages
Printing page [x]/
[y], copy [a]/[b] A sheet of print media moves
through the MFP to be printed.
x represents the number of the sheet
being printed. A sheet is considered
a front and back page of one piece of
print media. A group of sheets is
called a set. y represents the total
number of sheets in a set.
a is the number of the current set
printing. b is the total number of sets
to be printed. For example, a user
may send a 6-page duplex print job
and select three copies to print, so
there are three sheets to print for
each job. This makes one set. Three
sets must print before the user has
the complete job.
Programming Flash
DO NOT POWER OFF The MFP is storing resources, such
as fonts or macros, in flash memory. Warning: Do not turn the MFP off while this message
is displayed.
Wait for the message to clear.
Programming System
Code
DO NOT POWER OFF The MFP is programming new
system code. Warning: Do not turn the MFP off while this message
is displayed.
Wait for the message to clear and the MFP to reset.
Ready The MFP is ready to receive and
process jobs. Print, fax, scan, e-mail, copy, or use FTP.
Resetting the
Printer The MFP is resetting to the current
default settings. Any active print jobs
are canceled. Wait for the message to clear.
Restoring Factory
Defaults The MFP is restoring the factory
default printer settings. Wait for the message to clear.
Note: When factory default settings are restored:
• All downloaded resources (fonts, macros, symbol
sets) in the print memory are deleted.
• All menu settings from the LCD return to the factory
default setting except:
– The Display Language setting in the Setup Menu
– All settings in the Parallel Menu, Serial Menu,
Network Menu, Infrared Menu, LocalTalk Menu,
USB Menu, and Fax Menu
Standard Bin Full
[bin name] Full
The standard bin is full. Remove the stack of print media from the standard
output bin to clear the message.
Toner Low The print cartridge is low on toner.
The Menu Settings Page shows the
level. It takes an unspecified amount
of time for the MFP to read the level
of toner. Until the level is read, the
MFP does not show the message.
• The message clears automatically when the cover
or door over the print cartridge is opened or if the
MFP power is turned off and then on.
• Replace the print cartridge. If it is not replaced, the
MFP issues the message again when the door or
cover is closed.
Tray [x] Empty x represents the number of the tray.
The tray has no print media installed. 1 Remove the tray. The message clears.
2 Install print media in the tray according to the User’s
Guide.
3 Insert the tray.
Tray [x] Low x specifies the number of the tray
that is low. Load print media into the specified tray to clear the
message.
Message Meaning Action