Lexmark X642e MFP - Manuel (Page 55)

Settings
55
Using MFP menus
Enable ECM Enables Error Correction Mode for fax
jobs, which makes faxing more
reliable. On* ECM is enabled.
Off ECM is disabled.
Enable Fax
Scans Allows sending faxes by scanning at
the MFP. On* Fax scans are enabled.
Off Fax scans are disabled.
Driver to Fax Allows driver to fax jobs to be sent by
the MFP. On* Driver to fax jobs can be sent.
Off Driver to fax jobs cannot be sent.
Driver to fax jobs are treated like
PostScript jobs.
Allow Save as
Shortcut Allows for saving fax numbers as
shortcuts in the MFP. On* A Save as Shortcut button appears on
the screen.
Off A Save as Shortcut button does not
appear on the Fax Destination screen.
Dial Mode Specifies the dialing sound, either as a
tone or a pulse.
Note: This menu item may not be
available in all countries or regions.
Tone* A tone sounds for each number dialed.
Pulse A pulsating noise sounds for each
number dialed.
Background
Removal Adjusts the amount of background
visible on a copy. -4 to +4 (0*) -4 sets Background Removal to off.
+4 sets Background Removal to the
maximum allowed.
Contrast Specifies the contrast used for the
scan job. The default is dependent on
the Content menu item. If the Content
menu item is reset from the default
setting, then the default for Contrast is
reset also. 0–5
Best for content*
Best for content has a default value,
also, since the value is dependent on
the Content menu item. For more
information, see Content. If Content is
mono text, the Contrast default value
is 5. The default is 0 for items other
than mono text.
Any reset of the Content value resets
the default of the Best for content
value.
Shadow detail Adjusts the amount of shadow detail
visible on a copy. -4 to +4 (0*) -4 preserves the least amount of
shadow detail.
+4 preserves the most shadow detail.
Scan edge to
edge Specifies if the original document is
scanned edge-to-edge prior to sending
the fax job. Off*
On
Menu item Purpose Values and descriptions