Lexmark X642e MFP - Manuel (Page 104)

104
Attendance messages
53 Unformatted flash
detected The MFP detects unformatted flash
memory. Touch Continue to clear the message and
continue printing. The MFP continues with
normal operations except for flash operations.
Reformat the flash to allow flash operations.
If the error message reappears, the flash
memory may be defective and require
replacement.
54 Network [x] software
error The MFP cannot establish
communications with a specified
installed network port. x indicates the
number of the specified port. • Touch Continue to clear the message and
continue printing. The job may not print
correctly.
• The MFP disables attempts to communicate
through the network interface. No data may
be sent or received.
• Reset the MFP.
• Program new firmware for the network
interface.
54 Serial option [x]
error The MFP detects a serial error, such
as framing, parity, or overrun on the
specified optional serial port. x is the
number of the optional serial port. • Make sure the serial link is set up correctly,
and the appropriate cable is in use.
• Make sure the serial interface parameters
(protocol, baud, parity, and data bits) are set
correctly on the MFP and host computer.
• Touch Continue to clear the message and
continue processing the print job; however,
the print job may not print correctly.
• Turn the MFP off and then on to reset it.
54 Standard network
software error The MFP firmware detects an
installed network port, but cannot
establish communication with it. • Touch Continue to clear the message and
continue printing. The job may not print
correctly.
• The MFP disables attempts to communicate
through the network interface. No data may
be sent or received.
• Reset the MFP.
• Program new firmware for the network
interface.
55 Unsupported option in
slot [x] The MFP detects an unsupported
option in the specified slot. x indicates
the number of the specified slot. 1 Turn the MFP off.
2 Unplug the power cord from the wall outlet.
3 Remove the unsupported option.
4 Connect the power cord to a properly
grounded outlet.
5 Turn the MFP on.
56 Parallel port [x]
disabled A status request occurs over the
parallel port, but the parallel port is
disabled. Touch Continue. The MFP discards any data
received on the parallel port.
56 Serial port [x]
disabled The MFP receives data across a
serial port, but the port is disabled. Touch Continue. The MFP discards any data
received on the serial port.
56 Standard USB port
disabled The MFP receives data through a
USB port, but the USB port is
disabled. Touch Continue. The MFP discards any data
received through the USB port.
Make sure the USB Buffer menu item is not set
to Disabled.
56 USB port [x] disabled The MFP receives data through a
specified USB port, but this USB port
is disabled. x is the number of the
USB port. Touch Continue. The MFP discards any data
received through the specified USB port.
Make sure the USB Buffer menu item is not set
to Disabled.
Message Meaning Action