Lincoln Electric VANTAGE SVM178-B - Manuel (Page 37)

MAINTENANCE D1.5 D1.5
VANTAGE® 500
4. Slide the new element onto the grommet post on
the bottom of the filter header until the element no
longer easily moves up into the filter header. Now
rotate the element (it may take almost 1 full turn)
with a slight upward pressure until the element
begins to further engage the header. With the prop-
er orientation now established, apply additional
pressure to seat the element in the filter header.
You should feel the element “pop” into place when
properly seated.
NOTE: The element will only go on one way. Never use
excessive force when mounting the element to the
header.
5. Slide the quick change ring up over the element and
rotate counter clockwise until an audible click or
pop is heard. If you do not hear the click, you have
not rotated the ring far enough and the element is
not in the locked position. Another indication that
the ring is in the locked position is that one set (it
doesn’t matter which one) of arrows located on the
outside of the ring should be located directly under
the air vent valve.
6 . Open the fuel shutoff valve (lever in line with the
hose).
7 . Open the air vent valve on the front of the filter
header until fuel emerges free of air bubbles. Then
close the air vent valve.
Secondary Fuel Filter: The Secondary Fuel Filter is a
spin-on cartridge type mounted directly to the engine.
Consult your engine Operator’s Manual for complete
information on service intervals and element changing
procedures.
FIGURE D1.3 – SECONDARY FUEL FILTER
SECONDARY
FUEL FILTER
OIL
FILTER
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Section
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC
Return
to
Master
T
OC