JVC RX-DP15BC - Manuel (Page 51)

48
English
7 Submenu items
On this submenu, you can adjust the following items for each
channel:
BASS FREQ* : Select the center frequency to adjust bass
sounds from—63 Hz, 80 Hz, 100 Hz
(initial), 125 Hz, 160 Hz, 200 Hz, 250 Hz,
320 Hz, 400 Hz, 500 Hz, 630 Hz, 800 Hz,
1.0 kHz.
LEVEL : Adjust the enhancement level for bass sounds
(within the range of +6 dB to –6 dB).
MID FREQ* : Select the center frequency to adjust
middle-range sounds from—250 Hz,
320 Hz, 400 Hz, 500 Hz, 630 Hz, 800 Hz,
1.0 kHz (initial), 1.25 kHz, 1.6 kHz,
2.0 kHz, 2.5 kHz, 3.2 kHz, 4.0 kHz.
LEVEL : Adjust the enhancement level for middle-
range sounds (within the range of +6 dB
to –6 dB).
TREBLE FREQ* : Select the center frequency to adjust treble
sounds from—1.0 kHz, 1.25 kHz, 1.6 kHz,
2.0 kHz, 2.5 kHz, 3.2 kHz, 4.0 kHz, 5.0 kHz,
6.3 kHz, 8.0 kHz, 10.0 kHz (initial),
12.5 kHz, 16.0 kHz.
LEVEL : Adjust the enhancement level for treble
sounds (within the range of +6 dB to –6 dB).
Note:
* Adjustable range changes according to the other two frequency
settings.
1 Adjusting the Parametric Equalizer for Each
Channel—PEQ FRONT/CENTER/
SURROUND/SURR BACK
You can adjust equalization
patterns to your preference.
First, on the ADJUST MENU
screen, select the signal channel
(speaker) you want to adjust,
then move to its submenu.
Notes:
• This function is applied only to Zone 1 sources.
• If “NO” or “NONE” is selected for a speaker on the SPEAKER
SETTING submenu (see page 38), you cannot select the
corresponding channel.
• If THX is activated, Parametric Equalizer is not available.
• If “EXT 7.1CH” is selected as the source, Parametric Equalizer for
the surround back channel is not available.
7 Adjustment procedure
1 Press fi or % (DOWN or UP) to select the channel—PEQ
FRONT, CENTER, SURROUND, or SURR BACK, then
press SET.
The submenu of the selected channel appears.
2 Press fi or % (DOWN or UP) to select an item you want to
adjust on the submenu.
3 Press # or @ (RIGHT or LEFT) to adjust the item.
• Once one of the sound levels—“BASS LEVEL,” “MID
LEVEL” and “TREBLE LEVEL”—is adjusted, the
PARAMETRIC EQ indicator lights up on the display.
4 Repeat steps 2 and 3 to adjust the other items on the same
submenu.
5 Press EXIT once.
The ADJUST MENU appears again.
6 Repeat steps 1 to 5 to adjust the other channels.
To cancel the adjustment, set all the sound levels—“BASS
LEVEL,” “MID LEVEL” and “TREBLE LEVEL”—to “0 dB.”
The PARAMETRIC EQ indicator goes off.
:ENTER
:EXIT
ADJUST MENU
PEQ FRONT
CENTER
SURROUND
SURR BACK
MIDNIGHT MODE
EFFECT ADJUST
:OPERATE
:BACK
PARAMETRIC EQ
BASS FREQ : 100Hz
LEVEL: 0dB
MID FREQ : 1.0kHz
LEVEL: 0dB
TREBLE FREQ :10.0kHz
LEVEL: 0dB
Continued on the next page.
45-50_RX-DP15B[C]f.pm6 04.4.14, 3:10 PM 48