JVC RX-DP15BC - Manuel (Page 11)

8
English
AM Antenna Connections
Connecting the Speakers
For full enjoyment of the THX modes (see page 51), it is
recommended to use THX-certified speakers.
You can connect the following speakers:
• Two pairs of front speakers to produce normal stereo sound.
• One pair of surround speakers to produce a three-dimensional
sound movement and environmental background-effect sounds.
• One or one pair of surround back speakers to enjoy 6.1-channel or
7.1-channel sound reproduction. A pair of the speakers is required
to use THX Ultra2 Cinema and THX Music modes.
• One center speaker to produce a rich sound image by stabilizing
the sound localization (also used to emphasize human voices).
• One powered subwoofer to enhance the bass and to reproduce the
LFE channel recorded in multi-channel software.
For each speaker (except for a subwoofer), connect the (+) and (–)
terminals on the rear panel to the (+) and (–) terminals marked on
the speakers. For connecting a subwoofer, see page 10.
CAUTIONS:
Use only the speakers of the SPEAKER IMPEDANCE indicated by
the speaker terminals.
• When connecting to both of the FRONT 1 and FRONT 2 / ZONE
2 SPEAKERS terminals, use speakers with an impedance of
8
Ω to 16 Ω.
• When connecting to either the FRONT 1 or FRONT 2 / ZONE 2
SPEAKERS terminals, use speakers with an impedance of
4
Ω to 16 Ω.
Basic connecting procedure
1. Cut, twist, and remove the insulation at the end of
each speaker signal cable (not supplied).
2. Turn the knob counterclockwise.
3. Insert the speaker signal cable.
4. Turn the knob clockwise.
Outdoor single vinyl-covered wire (not supplied)
Turn the loop until you
have the best reception.
FM 75
COAXIAL
ANTENNA
AM
EXT
AM
LOOP
2 3 1
Notes:
• If the AM loop antenna wire is covered with vinyl,
remove the vinyl by twisting it as shown in the diagram.
• Make sure the antenna conductors do not touch any
other terminals, connecting cords and power cord. This
could cause poor reception.
• If reception is poor, connect an outdoor single vinyl-covered wire to
the AM EXT terminal. (Keep the AM loop antenna connected.) 2 3 4 1
Rear view
AM Loop Antenna
(supplied)
Snap the tabs on the loop into
the slots of the base to
assemble the AM loop.
Continued on the next page.
01-18_RX-DP15B[C]f.pm6 04.4.14, 2:59 PM 8