Resetting the lamp use time, Projector’s button – JVC DLA-G150CLU Manuel d'utilisation

Page 64

Advertising

Replacing the Light-Source Lamp

DLA-G150CLU / LCT1123-001B / ENGLISH

■ Resetting the Lamp Use Time

After replacing with a new light-source lamp, reset the lamp-time counter inside the projector to clear the accumulated lamp
time to zero (0). After resetting, a new count will start for the new light-source lamp.

■ Projector’s button

Turn on the MAIN POWER switch to go
into stand-by mode.

In stand-by mode, the STAND BY indicator on the
projector lights up.

Press the following buttons on the
projector, sequentially.

Momentary press the PC button.

Momentary press the ENTER button.

Momentary press the EXIT button.

Press and hold the HIDE button for two seconds
or more.

* During this sequence, the STAND BY and OPERATE

indicators alternately blink about every approx. 3 seconds.
After completion of the sequence, the STAND BY indicator
alone stays on.

* Buttons must be pressed within 2 seconds of the previous

button.

* When you make a mistake in button operations, return to

the beginning of the sequence.

* To check the lamp time on the menu, press the MENU button

and select “Information” with the cursor button

∞

The lamp use time is indicated in the item “Lamp time”.

Video main menu

PC main menu

CAUTION

• Reset the lamp use time only when you have replaced with

a new light-source lamp. Never reset it during lamp life,
otherwise the replacement time may become unclear, and
lead to degraded performance or lamp explosion.

LAMP

TEMP

STAND BY

HIDE

VIDEO

MENU

KEYSTONE

PRESET

EXIT

ENTER

OPERATE

Cursor buttons

5/∞

PC
button

ENTER
button

EXIT
button

HIDE
button

STAND BY
indicator

MENU
button

OPERATE
indicator

Input

Switcher

Source

Lamp time

VIDEO

CH.0

NTSC

123 h

Image adj.

Setting

Color temp.

Options

Language

Information

Lamp time (0 h)

Input

Switcher

Resolution

Frequency H

Frequency V

Lamp time

PC 1

CH.0

1280 1024

79.9

123

kHz