JVC DLA-G150CLU - Manuel (Page 31)

29
Connecting to Various Devices
ENGLI
S
H
DEUTSH
FRAN
Ç
AIS
ITALIANO
ESPA
Ñ
OL
DLA-G150CLU / LCT1123-001B / ENGLISH
Connecting to DVI
Before connection, be sure to turn off both the projector and computer devices.
• Read thoroughly the manual that comes with each device.
Note
• Other connections are the same as in the connection example for IBM PC or IBM compatible PCs.
How to attach the ferrite core
Attach the ferrite core when using the S-video cable or infrared remote sensor extension unit which are sold separately.
However, use a cable that can be wound once.
1 Release the stopper at each end and
open the ferrite core.
2
Wind the cord around the ferrite core.
Attach the ferrite core about 3 cm from the end of the
cord.
3 Close the ferrite core with the cord
inside until you hear it click shut.
Note
• When connecting, connect the terminal which is at the
ferrite core end of the cord to the projector.
Y
P
P
IN
R
G
B
H
IN
V DOS/V
(DVI VIDEO BOARD)
DVI (DVI-D 24pin Cable)
(Available separately)
Click!
Stoppers
Wind the cable once.
DLA-G150CLU&CLE_Eng.book Page 29 Thursday, February 21, 2002 2:39 PM