JVC VR-510U - Manuel (Page 12)

12
4 PREPARATION
4-1 Installing a battery
1. Turn the [POWER] switch OFF.
2. Open the battery cover.
While pushing down the pawl in the upper section of the
battery cover, pull it towards you to open the cover.
3. Install a battery.
Install the provided battery (CR2032) with the + side
facing you.
4. Close the battery cover.
Close it until the pawl is locked firmly.
Caution:
● When the power is supplied, do not replace the battery.
Otherwise, a malfunction may occur.
● Replace the battery with a CR2032 type battery. Using
any other type of battery may present a risk of fire or
explosion.
Memo:
● When you replace the battery, be sure to set the date
and time again.
Reference: “4-3 Setting the date and time” on page 13.
● After replacing the battery, be sure to program the
program timer again because the programs are reset.
● When “LOW BATTERY” is displayed, check the battery
again.
4-2 Power supply
[AC IN] socket
1. Connect the power cable.
Connect the provided power cable to an AC 120 V outlet.
2. Press the [POWER] switch to ON.
The system check starts for this unit and “SYSTEM
LOADING ...” is displayed on the monitor.
“LoAd--” blinks on the display panel.
Caution:
● After all other equipment connections are complete,
turn the power of this unit ON.
Memo:
● All operation functions are disabled during system
check. Wait until “SYSTEM LOADING ...” goes out.
POWER
WARNING
SLEEP REC STOP PLAY STILL
TIMER CANCEL
DISPLAY
MENU
SEARCH
SELECT
REV FWD
EXECUTE
SKIP/ALARM SEARCH
REC
CLOCK RESET/ CLEAR
OPE. LOCK
ON
DIGITAL VIDEO RECORDER VR-510U
2.
3.
CAMERA IN
MONITOR OUT
1
1
2
1 2
AUDIO
IN
AUDIO
OUT
RS-232C
POWER
SIGNAL GND
CAM SW OUT ALARM IN1
SPARE SPARE
SPARE HDD FULL OUT
ALARM
RESET CLOCK RESET IN CLOCK RESET OUT
EXT REC IN
COM COM
ON OFF I O
AC IN 120 V
50 Hz / 60 Hz
[POWER] switch
VN
S