JVC RX-8040B - Manuel (Page 42)

40
English
Adjusting the equalization patterns
You can adjust the equalization patterns to your preference.
• Once you have made an adjustment, it is memorized for each
source.
• The equalization pattern affects the front speaker sounds only.
7 Equalization adjustment—EQ 63Hz, EQ250Hz,
EQ 1kHz, EQ 4kHz, EQ16kHz
You can adjust five frequencies (63 Hz, 250 Hz, 1 kHz, 4 kHz,
16 kHz) within the range of –8 dB to +8 dB (“0 (dB)” is the
initial setting) in 2 dB steps.
• When an adjustment is made, the D.EQ indicator lights up on
the display.
To flat the equalization pattern, set all the frequencies to
“0 (dB)” in step 4 of “Basic Procedure” on the left column.
The D.EQ indicator goes off from the display.
Note:
When Analog Direct is in use, Equalization patterns are not
available.
Adjusting the speaker output levels
You can adjust the speaker output levels.
• Once you have made an adjustment, it is memorized for each
source.
7 Adjustable speakers
You can adjust the following speakers’ output levels within the
range of –10 dB to +10 dB (“0 (dB)” is the initial setting):
SUBWFR LVL Select to adjust the subwoofer output level.
FRNT L LVL Select to adjust the left front speaker output
level.
FRNT R LVL Select to adjust the right front speaker output
level.
CENTER LVL Select to adjust the center speaker output
level.
SURR L LVL Select to adjust the left surround speaker
output level.
SURR R LVL Select to adjust the right surround speaker
output level.
SBACK LVL Select to adjust the surround back speaker
output level.
Notes:
• If you have selected “NO” or “NONE” for a speaker (see page
34), the output level for the corresponding speaker is not
adjustable.
• Speaker output levels (except the subwoofer output level) are
not adjustable when Analog Direct is in use. But when you
canceled the subwoofer output using the SUBWOOFER OUT
ON/OFF button (see page 22), you also cannot adjust the
subwoofer output level.
Basic Procedure
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
Ex. When adjusting the subwoofer level to “–3.”
1. Press ADJUST.
The last selected item appears on the display.
2. Turn MULTI JOG until an item you want
appears on the display.
• In this example, select “SUBWFR LVL.” For available items,
see the list “Basic Adjustment Items” on page 39.
3. Press in MULTI JOG (PUSH SET).
The current setting (or level) for the selected item appears on the
display.
4. Turn MULTI JOG to select a setting you want or
to make an adjustment as you like.
5. Press in MULTI JOG (PUSH SET).
6. Repeat steps 2 to 5 to set other items if necessary.
7. Press EXIT.
The source indication resumes on the display.
LINEAR PCM L
SUBWFR
R
ANALOG
VOLUME
SPEAKERS 1
ZONE 1
LINEAR PCM L
SUBWFR
R
ANALOG
VOLUME
SPEAKERS 1
ZONE 1
LINEAR PCM L
SUBWFR
R
ANALOG
VOLUME
SPEAKERS 1
ZONE 1
LINEAR PCM L
SUBWFR
R
ANALOG
VOLUME
SPEAKERS 1
ZONE 1
39-41_8040[C].p65 04.5.14, 11:29 40