JVC RX-8040B - Manuel (Page 34)

32
English
Basic Settings
Some of the following settings are required after connecting and positioning your speakers while others will make
operations easier. You can use QUICK SPEAKER SETUP to easily set up your speaker configuration.
Basic setting operations are only possible while the receiver is ready for Zone 1 operations.
IMPORTANT:
Check the following before or while using the buttons and controls.
For Zone 1 operations:
The ZONE 1 indicator lights up on the unit’s display.
• When using the unit:
– “ZONE2” is not shown in the unit’s main display.
Quick Speaker Setup
Quick Speaker Setup helps you to easily and quickly register the
speaker size and speaker distance according to your listening room
to create the best possible surround effect.
• You can also register each speaker’s information manually.
For details, see page 34.
Before you start, remember...
There is a time limit in doing the following steps. If the setting is
canceled before you finish, start from step 1 again.
1. Press QUICK SPEAKER SETUP.
“SETUP” and “SPEAKERS?” appear on the display, then the
initial setting for the total number of the connected speakers
(channels) appears.
2. Turn MULTI JOG to select an appropriate
number of the connected speakers (speaker
channel number).
As you turn the jog, the speaker channel number changes as
follows.
• For the details of speaker channel number, see “Speakers
(channels) number and the size” on page 33.
* “6.0CH” is the initial setting.
LINEAR PCM L R
ANALOG
LINEAR PCM L R
ANALOG
VOLUME
SPEAKERS 1
VOLUME
SPEAKERS 1
ZONE 1
ZONE 1
Remote
NOT
3. Press in MULTI JOG (PUSH SET).
“ROOM SIZE?” appears on the display, then the initial room
size setting appears.
4. Turn MULTI JOG to select an appropriate room
size to match to your listening room.
As you turn the jog, the room size changes as follows.
• To select your appropriate room size, see “Room size and the
speaker distance” on page 33.
* “LARGE” is the initial setting.
5. Press in MULTI JOG (PUSH SET).
“COMPLETE” appears on the display, then goes back to the
source indication.
• Speaker configuration settings now become active.
Notes:
• This procedure will not be completed if you stop in the middle of the
setting process.
• Once Quick Speaker Setup is performed, the speaker output levels
are also set to appropriate values automatically (common to all
sources). If you want to set the speaker output levels separately for
each source, see “Adjusting the speaker output levels” on page 40.
L R
ANALOG
2.0CH “ 2.1CH “ 3.0CH “ 3.1CH “ 4.0CH “
4.1CH “ 5.0CH “ 5.1CH “ 6.0CH* “ 6.1CH “
7.0CH “ 7.1CH “ (Back to the beginning)
VOLUME
SPEAKERS 1
ZONE 1
LINEAR PCM L R
ANALOG
LINEAR PCM L R
ANALOG
VOLUME
SPEAKERS 1
VOLUME
SPEAKERS 1
ZONE 1
ZONE 1
LINEAR PCM L R
ANALOG
SMALL “ MID “ LARGE* “ (Back to the beginning)
VOLUME
SPEAKERS 1
ZONE 1
LINEAR PCM L R
ANALOG
VOLUME
SPEAKERS 1
ZONE 1
32-38_8040[C].p65 04.5.14, 11:29 32