Labconco WaterPr PS Systems 90007 Series - Manuel (Page 18)

Chapter 3: Getting Started
14
Original Instructions
Setting Up the WaterPro PS System
Unfold the installation template included and follow the instructions to mount the WaterPro PS
System on a suitable wall.
If the optional Wall Mounting Panel, Support Stand or WaterPro PS/PS Mobile Stand has been
purchased, discard the templates and follow instructions provided with the option.
When installing the WaterPro PS the unit should be lifted in place and supported from the bottom
by two people on both sides of the unit.
Feedwater and Drain Connection
The supplied feedwater is 3/8" OD (0.95 cm) rigid plastic tubing. If more tubing is required, refer
to Replacement Parts section in this manual. The tubing is inserted into the inlet port. At a
convenient spot in the supply line, a valve should be installed so the WaterPro PS may be isolated
from the feedwater supply when required. Line pressure should not exceed 100 psi (7 Bar).
To connect the feedwater supply to the inlet port, cut the tube square, check for burrs, and insert
into the inlet water fitting as explained in the Tubing Installation section below.
Drain Connections
The HPLC, UF and Hybrid models are equipped with a drain line that must be routed to an open
drain. Install the flexible tubing provided into the fitting marked drain, it is important to weight the
line or attach permanently to the drain to prevent the line from coming out of the drain due to the
water pressure during the flush cycle.
Tubing Installation
The tubing connectors used in the WaterPro PS have been selected for their dependability and ease
of installation. A detailed drawing of a typical connection is shown in Figure 3.
For flexible tubing, be sure to insert a tube support into the end of the tubing. Rigid tubing does
not require the use of a tube support.
Figure 3