RCA VR663HF - Manuel (Page 33)

Reference:
TW>uble Checks
IVouble
Rewind does not operate
Here's what to try:
VCR PLUS display appears
on TV instead of VCR MAIN MENU when you
press PROG/VCR+ on remote.
VCR Plus+ or Timer recording not made
or wrong program recorded
Tape already rewound.
• After VCR PLUS has been used, the VCR PLUS display will appear
automatically when you press PROGA/CR+ on remote. Press PROG/VCR+
again to display the VCR MAIN MENU,
Clock shows incorrect time or date
VCR makes noise when stopped
Will not AutoProgram active
channels correctly
Tape plays back in slow motion
Cannot select cable channels over 69
VCR and remote buttons will not operate VCR
Stereo or SAP sound not recorded
No stereo sound during playback
Stereo audio too noisy
T
Code number for VCR Plus+ program entered incorrectly. See page 11.
VCR Plus+ setup not done or done incorrectly. See pages 10-21.
Cable box was not turned on at time recording was to begin or cable box
set-up was not done correctly. See page 11.
Program entered incorrectly (wrong channel or times).
Power interruption. Clock area in display panel will show —; —,
Check to see if time and date are correct - including AM/PM.
Program exceeded tape's length or tape was not rewound beforehand.
VCR was not turned off at the time recording was to start.
No tape in VCR, or cassette is ejected if safety tab is broken off.
VCR ejects cassette when the end of the tape is reached during a timer
recording.
• Power interruption. Clock on the front panel wOl show — : —,
• Clock was not set accurately (check AM/PM and date).
• Time counter display appears in VCR's display panel. Press DISPLAY on
remote.
• VCR is removing tape from heads. This is normal. The head cylinder inside
the VCR will continue to rotate for a few minutes after you put the VCR in
the stop mode.
• Check antenna connections.
• Check CABLE/ANT: feature to make sure it is properly set. See page S.
• Press PLAY/PAUSE on VCR or PLAY on remote to return to normal playback.
• Cable channels over 69 can only be selected if CABLE/ANT feature is set to
CABLE. Details are on page 8.
• Pro-Tect Plus feature turned on. Press and hold VCR1 (VCR2) button on
remote for five seconds to turn Pro-Tect Plus off. HELLO appears in VCR's
display panel.
• ST/MONO/SAP feature must be set to STEREO to record broadcast stereo.
Seepage 19.
• ST/MONO/S/VP feature must be set to S/VP to record SAP. See page 19.
• STEREO indicator not on. Station not broadcasting stereo.
AUDIO PLAY (HIFI/MIX/LINEAR) feature must be set to HIFl to hear stereo
sound during playback. See page 17.
Stereo signal is weak. Set ST/MONO/SAP feature to MONO.
Press one of the TRACKING buttons on the remote to minimize the noise.
31