RCA VR663HF - Manuel (Page 10)

Setting Up the VCR
Startup
1. Check accessories with VCR.
Contact your dealer if any items are missing.
' OlO tì
I O W iypS3>ooe»:>
Remote
(Stock No. 218103}
2 “AA” Batteries Power Cord RF Coaxial Cable
(Stock No. 218104) (Stock No. 206085)
2. Attach power cord to back of VCR.
3. Insert batteries
4. TUrn on the TV.
A. Turn on the TV.
B, If you used one of the basic hookups, tune the TV to the channel
selected with the CH4 CH3 switch on back of VCR.
If you used one of the advanced hookups, tune the TV to
the TV's video input. (See TV's owner's manual for details.)
5. Tkirn on the VCR.
A. Press VCR1 (VCR2) on the remote.
6. Place channels in the VCR’s memory (AutoProgram).
Channels 2 through 13 are in the VCR's memory when you first turn it on.
Pressing CHANNEL up or down stops on these channels. To get additional
channels available on your antenna or cable system, you must AutoProgram
the VCR.
A. Press VCR1 (VCR2) to set remote to control VCR..
B. Press PROGA/CR+ on the remote to see the VCR MAIN MENU on
the TV screen. If the menu does not appear on the TV screen;
• Make sure TV is tuned to same channel as CH4 CHS switch on
VCR or the TV's video input (refer to TV's manual).
• Press VCR1 (VCR2), and then press PROGA/CR+.
• If you use a basic hookup, check VCR indicator in display panel -
it should be on. Press TVA/CR to turn it on.
• Check the connections.
C. When menu appears, press 5 to select SET UP VCR.
D. Press 1 to begin AUTOPROGRAM CHANNELS.
Wait until the channel numbers stop changing. This takes about
one to two minutes. The TV will then tune to the lowest channel found.
Pressing CHANNEL up or down will select only the active channels.
The VCR automatically selects ANTENNA or CABLE. If you need to
change the setting manually, press 3,
1 AUTOPROGRAM CHANNELS
2 ADD/ERASE CHANNELS
3 CABLE/ANT: ANTENNA
A SET UP CABLE BOX
5 SET UP VCR PLUS
6 ST/MONO/SAP: STEREO
7 AUDIO PLAY:
HIFI
8 REMOTE CONT: VCR1
PRESS NUMBER TO SELECT
PRESS PROGRAM TO END
8
continued on next page