RCA VR663HF - Manuel (Page 28)

Recording n Prognim
Using Two VCRs for Copying and Editing Tapes
Operating Instructions (Refer to hookup on ряде 6-i
Use one VCR as the playback VCR and the other as the recording VCR.
1. Turn on the TV and VCRs.
Caution: The unauthorized
recording of television
pTogranrs and other
materials may infringe the
rights of others.
2. Tune TV to the VCR viewing channel, either 3, 4, or TV's video input.
3. If you have connected your VCR using Option A (page 6), tune recording
VCR to channel 3 or 4 - the one selected on the back of the playback VCR.
If you have connected your VCR using Option B (page 6), press INPUT
on recording VCR's remote to select the line input- L appears in VCR's
display panel.
4. Insert the tape you want to copy into playback VCR. Insert a blank tape
with safety tab in place into recording VCR.
5. Press PLAY/PAUSE on the playback VCR to play the tape. When you reach
the point on the tape or program where you want to begin copying, press
PLAY/PAUSE to pause the tape. If streaks appear, you may need to adjust
TRACKING.
6. Press RECORD, then PLAY/PAUSE on recording VCR.
7. Press PLAY/PAUSE buttons on both VCRs at the same time to begin
copying the tape.*
8. Edit out segments that you do not want to copy by pressing PLAY/ PAUSE
on recording VCR to stop copying the tape. Then, locate the next segment
you want to copy on playback VCR by using F.FWD, REW, and
PLAY/PAUSE. Then press PLAY/PAUSE on the playback VCR to pause
the tape. Press PLAY/PAUSE at the same time on both VCRs to resume
copying.
9. Press STOP/EJECT on both VCRs when you are finished.
* You may turn off the TV after the recording has started as it does not have to
be on to copy a tape.
Using Dual Remote with AutoEdit™
Use this VCR as the recording VCR and set it to respond to VCR2 on the remote
as described on page 12. Use your other compatible VCR as the playback VCR,
which should respond to VCR1.
1. Follow steps 1 - 4 in "Operating Instructions" above.
2. FYess VCR2 on remote to control recording VCR. Press REC/XPR, then
PAUSE, to put recording VCR in pause mode.
3. Press VCR1 on remote to control playback VCR.
4. Use PLAY, F.FWD, and REW, to locate the point where you want to begin
copying. Press PAUSE while VCR is playing to put playback VCR in pause
mode.
5. Press EDIT on remote; the VCRs will begin copjdng.
6. Press EDIT again when you want to stop the tape from copying.
7. Repeat steps 4 - 6 as needed.
8. Press VCR1, STOP, then VCR2, STOP, when you are finished.
26