Pioneer DV-636D - Manuel (Page 12)

12
En
Rear Panel
CONTROL OPT.
AUDIO OUT (2CH) AUDIO OUT (5.1CH)
AC IN
VIDEO OUT
NTSC
PAL AUTO
OUT IN
R
2 1
R
L L 1
2
1
2
FRONT SUB
WOOFER
CENTER
TV SYSTEM
AV CONNECTOR
DIGITAL OUT
SURROUND
S-VIDEO
OUT
AV2 AV1 (RGB) -TV
1 2
8 9 7 6
3 4 5
1
CONTROL jacks
Use to connect this player to another component
bearing the Pioneer
Î mark. This lets you control
this unit as though it were a component in a system.
Player operations are then performed by pointing the
remote control at the component that the player is
connected to (page 20).
2
AV CONNECTOR jacks
AV 1 (RGB)-TV jack
Use a 21-pin SCART cable to connect to a TV or
monitor compatible with this type of connection.
Both audio (2 channel stereo) and video (Video,
S-video, and RGB) signals are output from the AV 1
(RGB)-TV jack (page 20).
AV 2 jack
Use a 21-pin SCART cable to connect to a VCR (page
20).
3
AUDIO OUT (2CH) jacks
Use to output two-channel audio (analog) to the
audio stereo inputs on a TV or stereo amplifier. If you
are connecting to a receiver that has both digital and
analog input jacks for DVD player connection, it may
be beneficial to make both connections (pages 15,
18).
4
AUDIO OUT (5.1CH) jacks
Use to output 6 discrete audio channels of decoded
digital audio to a receiver or amplifier with discrete
audio inputs (pages 16, 18).
5
AC IN power cord connection terminal
Use to connect the power cord to the wall outlet
(pages 15, 16).
6
S-VIDEO OUT jacks
If your TV or monitor has an S-video input, clear
picture reproduction is possible by connecting the
player to your TV or monitor via the S-video jack
(pages 16, 19).
7
VIDEO OUT jacks
Connect to the video input on a TV or monitor or AV
amplifier or receiver with video input capability
(pages 15, 19).
8
TV SYSTEM switch
Use to change the TV signal mode to either PAL or
NTSC according to the type of TV and disc to be
used. When the switch is in the AUTO position, the
player outputs the format on the disc as is (page 19).
9
DIGITAL OUT jacks (coaxial, optical (OPT.))
Use to output the digital audio signal recorded on
discs. You can output the digital signal via either
coaxial or optical output jack to an AV amplifier or
receiver (pages 16, 17).