Napoleon Fireplaces Bayfield - GDS25 - Manuel (Page 28)

5.4 LOG PLACEMENT
LOG LOCATING SCREWS
BRACKET
It is not necessary to remove the cast front, however, this will make for a more simple log installation.
In order to assemble the log set, the glass door must be removed, see “CAST FRONT / GLASS DOOR
INSTALLATION AND REMOVAL” section.
A. Place the rear log, as shown, onto the rear
log support brackets. Ensure the cutout on
the left underside of the log, fi ts over the pilot-
assembly. Bend the bracket on the left side to
help retain the rear log.
B. Place the hole in the underside of log #2
onto the locating screw, on the left side of the
burner. The fi bre burner is formed to cradle
the centre of the log.
C. Place the hole in the underside of log #3 onto
the locating screw, on the right side of the
burner. The bottom branch of log #3 sits in
front of, and against, the right end of log #2.
D. Reinstall the glass door & front.
!
WARNING
LOGS MUST BE PLACED IN THE EXACT LOCATION IN APPLIANCE. DO NOT CHANGE FROM THE
PROPER LOG POSITIONS. APPLIANCE MAY NOT FUNCTION PROPERLY.
THE LOGS ARE FRAGILE AND SHOULD BE HANDLED WITH CARE.
W415-0547 / J / 07.16.13
28
EN