Ohaus I5S Indicator - Manuel (Page 8)

7
Unpacking Unpacking Unpacking Unpacking Unpacking
Unpack the I 5S indicator at the installation site and verify that the following items
were included in the carton:
•
an AC Adapter
•
2 security screws
•
a capacity card
•
2 washers
•
a warranty card
•
instruction manual
It is recommended to save the carton and packing material for storing, transporting
the indicator or returning it for service.
Assembly Assembly Assembly Assembly Assembly
Assembly consists of making the necessary electrical connections, and applying
power to the unit.
Scale Base Connections Scale Base Connections Scale Base Connections Scale Base Connections Scale Base Connections
1. Remove two screws from the right
end cap using a phillips screwdriver.
2. Slide the printed circuit board par-
tially out of the housing and discon-
nect the battery cable connector.
3. Pass the scale base cable through
the liquid tight connector on the end
cap.
Housing
End Cap
Liquid Tight
Connector
Terminal Block for
Scale Base Wire
Connections
(Bottom)
Power
Connector
Battery Cable
Connector
Introduction and Installation 1 1 1 1 1