Ohaus I5S Indicator - Manuel (Page 36)

35
Operation 3 3 3 3 3
Selecting a Weighing Unit Selecting a Weighing Unit Selecting a Weighing Unit Selecting a Weighing Unit Selecting a Weighing Unit
Repeatedly pressing will cause
the displayed unit indicator to change.
Only the units which are set to ON in the
setup mode will appear. If the desired
unit indicator does not appear, refer to
Chapter 2 f or setup instructions.
Weighing Weighing Weighing Weighing Weighing
1. Make sure there is no load on the
scale base.
2. Press to obtain a zero read-
ing if necessary.
3. Add the load to the scale base and
read the weight on the display.
When the stability indicator ( )ap-
pears in the display, the reading is
stable.
*