Ohaus I5S Indicator - Manuel (Page 13)

12
Setup Mode and the Setup Mode and the Setup Mode and the Setup Mode and the Setup Mode and the I II II 5S Menu Structure 5S Menu Structure 5S Menu Structure 5S Menu Structure 5S Menu Structure
Programmable features of the I 5S are contained in menus which are accessed in
the Setup mode. The chart on page 2-3 shows how these menus are structured.
To access the main menu and change settings: To access the main menu and change settings: To access the main menu and change settings: To access the main menu and change settings: To access the main menu and change settings:
1. Make sure the indicator is OFF and the menu protection lockout switch on the
PC board is in the OFF position.
2. Press and hold until SETUP is displayed, then release it.
For first time setup, you must go through all of the submenus to configure the
indicator. After the indicator is in use, you can make changes to individual settings
and bypass others.
The following rules apply when using the setup mode:
•
Press to enter the displayed submenu or select a displayed setting.
•
Press to change the displayed submenu or setting.
To exit a submenu, save settings and return to the main menu: To exit a submenu, save settings and return to the main menu: To exit a submenu, save settings and return to the main menu: To exit a submenu, save settings and return to the main menu: To exit a submenu, save settings and return to the main menu:
Repeatedly press until END is displayed, then press .
To exit the main menu and return to the weighing mode: To exit the main menu and return to the weighing mode: To exit the main menu and return to the weighing mode: To exit the main menu and return to the weighing mode: To exit the main menu and return to the weighing mode:
You must be in the main menu with either SETUP, SCALE, CAL or RS232
displayed.
Repeatedly press until END is displayed, then press to exit and return
to the weighing mode.
2 2 2 2 2 Setup and Calibration