Pioneer MODE D'EMPLOI DEH-P780MP - Manuel (Page 68)

Calibrating the RPMs
Follow the instructions below to measure the
RPM of your vehicle and records them. By
doing this, the tachometer of this unit can
work properly.
! Tachometer of this unit cannot work if you
do not perform the RPM calibration.
! In some vehicles, the tachometer may not
work properly even if you performed the
RPM calibration.
1 Park your vehicle in a safe place and be
sure to apply the parking brake.
2 Use MULTI-CONTROL to select
Calibration.
Calibration appears in the display.
3 Keep RPMs of the engine at 4 000 rpm
and press MULTI-CONTROL.
To measure the RPM of your vehicle properly,
keep RPMs of the engine at 4 000 rpm for a
few seconds.
When the RPM calibration is completed,
Completed is displayed.
# Some vehicles have a rev limiter that kicks in
early (e.g., 3 000 rpm) while parking. In this case,
perform RPM measurement at 2 000 rpm.
# To switch between 4000 rpm and 2000 rpm,
push
MULTI-CONTROL left or right.
Initial Settings
En
68
Section
14