Tuner listening to the radio, Listening to the radio, Tuner – Pioneer MODE D'EMPLOI DEH-P780MP Manuel d'utilisation
Page 16
Listening to the radio
4
4
4
4
3
3
3
3
5
5
5
5
2
2
2
2
1
1
1
6
6
6
These are the basic steps necessary to operate
the radio. More advanced tuner operation is
explained starting on the next page.
1 Stereo (
5) indicator
Shows when the selected frequency is
being broadcast in stereo.
2 LOC indicator
Shows when local seek tuning is on.
3 Band indicator
Shows which band the radio is tuned to, AM
or FM.
4 Preset number indicator
Shows which preset has been selected.
5 Frequency indicator
Shows the frequency to which the tuner is
tuned.
6 Signal level indicator
Shows the radio wave strength.
1
Press SOURCE to select the tuner.
Press
SOURCE until you see Tuner displayed.
2
Press BAND to select a band.
Press
BAND until the desired band (FM-1,
FM-2, FM-3 for FM or AM) is displayed.
3
To perform manual tuning, push
MULTI-CONTROL left or right.
The frequencies move up or down step by
step.
4
To perform seek tuning, push and hold
MULTI-CONTROL left or right for about one
second and release.
The tuner will scan the frequencies until a
broadcast strong enough for good reception is
found.
# You can cancel seek tuning by pushing
MULTI-CONTROL left or right.
# If you push and hold MULTI-CONTROL left or
right you can skip stations. Seek tuning starts as
soon as you release
MULTI-CONTROL.
Tuner
En
16
Section
04