Attaching the front panel 10, About the demo mode, Reverse mode 10 – Pioneer MODE D'EMPLOI DEH-P780MP Manuel d'utilisation

Page 10: Feature demo mode 10, Use and care of the remote control, Installing the battery 10, Before you start

Advertising
background image

Attaching the front panel

1

Make sure the inner cover is closed.

2

Replace the front panel by clipping it

into place.

About the demo mode

This unit features two demonstration modes.
One is the reverse mode, the other is the fea-
ture demo mode.

Important

The red lead (ACC) of this unit should be con-
nected to a terminal coupled with ignition switch
on/off operations. If this is not done, the vehicle
battery may be drained.

Reverse mode

If you do not perform an operation within
about 30 seconds, screen indications start to
reverse, and then continue reversing every 10
seconds. Pressing

BAND when power to this

unit is turned off while the ignition switch is
set to ACC or ON cancels the reverse mode.
Press

BAND again to start the reverse mode.

Feature demo mode

The feature demo automatically starts when
power to this unit is turned off while the igni-
tion switch is set to ACC or ON. Pressing

DISPLAY during feature demo operation can-
cels the feature demo mode. Press

DISPLAY

again to start the feature demo mode. Remem-
ber that if the feature demo continues operat-
ing when the car engine is turned off, it may
drain battery power.

Use and care of the remote
control

Installing the battery

Slide the tray out on the back of the remote
control and insert the battery with the plus (+)
and minus (

–) poles pointing in the proper di-

rection.
! When using for the first time, pull out the

film protruding from the tray.

WARNING

Keep the battery out of the reach of children.
Should the battery be swallowed, immediately
consult a doctor.

CAUTION

! Use only one CR2025 (3 V) lithium battery.
! Remove the battery if the remote control is not

used for a month or longer.

! Do not recharge, disassemble, heat or dispose

of the battery in fire.

! Do not handle the battery with metallic tools.
! Do not store the battery with metallic materi-

als.

! In the event of battery leakage, wipe the re-

mote control completely clean and install a
new battery.

Before You Start

En

10

Section

01

Advertising