Pioneer MODE D'EMPLOI DEH-P780MP - Manuel (Page 60)

2 Push MULTI-CONTROL left or right to
select slope.
Each time
MULTI-CONTROL is pushed left or
right, slopes are selected in the following
order:
–12— –6—Pass (0) (dB/oct.)
# If you set the slope to 0 dB/oct. (Pass), the
audio signal bypasses the filter, so the filter does
not have an effect.
3 Turn MULTI-CONTROL to select
Rear HPF FREQ.
Rear HPF FREQ. appears in the display.
4 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time
MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50
—63—80—100—125—160—200 (Hz)
Only frequencies higher than those in the se-
lected range are output from the rear speak-
ers.
5 Push MULTI-CONTROL up or down to
adjust the output level of the rear speak-
ers.
Each time
MULTI-CONTROL is pushed up or
down, the level of the rear speakers increases
or decreases.
0 to
–24 is displayed as the level
is increased or decreased.
Using the equalizer
The equalizer lets you adjust the equalization
to match car interior acoustic characteristics
as desired.
Recalling equalizer curves
There are seven stored equalizer curves which
you can easily recall at any time. Here is a list
of the equalizer curves:
Display Equalizer curve
Powerful Powerful
Natural Natural
Vocal Vocal
Flat Flat
Custom1 Custom 1
Custom2 Custom 2
Super Bass Super bass
! Custom1 and Custom2 are adjusted equal-
izer curves that you create. Adjustments
can be made with a 16-band graphic equal-
izer.
! When Flat is selected no supplement or
correction is made to the sound. This is
useful to check the effect of the equalizer
curves by switching alternatively between
Flat and a set equalizer curve.
% Press EQ to select the equalizer.
Press
EQ repeatedly to switch between the fol-
lowing equalizers:
Powerful
—Natural—Vocal—Flat—Custom1
—Custom2—Super Bass
Adjusting equalizer curves
The factory supplied equalizer curves, with the
exception of
Flat, can be adjusted to a fine de-
gree (nuance control).
1 Use MULTI-CONTROL to select the gra-
phic equalizer adjustment.
Powerful appears in the display.
# If the equalizer curve has been previously se-
lected, the curve of that previously selected will
be displayed instead of
Powerful.
2 Push MULTI-CONTROL left or right to
select an equalizer curve.
Each time
MULTI-CONTROL is pushed left or
right, equalizer curves are selected in the fol-
lowing order:
Audio Adjustments
En
60
Section
13