Switching the auxiliary setting, Switching the dimmer setting, Adjusting the brightness – Pioneer MODE D'EMPLOI DEH-P780MP Manuel d'utilisation

Page 66: Correcting distorted sound, Switching the sound muting/attenuation, Initial settings

Advertising
background image

Switching the auxiliary setting

Auxiliary equipments connected to this unit
can be activated individually. Set each AUX
source to ON when using. About connecting
or using auxiliary equipments, refer to Using
the AUX source on page 69.

1

Use MULTI-CONTROL to select AUX1/

AUX2.
AUX1/AUX2 appears in the display.

2

Press MULTI-CONTROL to turn AUX1/

AUX2 on.
ON appears in the display.

# To turn AUX off, press MULTI-CONTROL
again.

Switching the dimmer setting

To prevent the display from being too bright at
night, the display is automatically dimmed
when the car

’s headlights are turned on. You

can turn the dimmer on or off.

1

Use MULTI-CONTROL to select Dimmer.

Dimmer appears in the display.

2

Press MULTI-CONTROL to turn dimmer

on.
ON appears in the display.

# To turn dimmer off, press MULTI-CONTROL
again.

Adjusting the brightness

You can adjust the display brightness. Initially
this mode is set to

24.

1

Use MULTI-CONTROL to select

Brightness.
Brightness appears in the display.

2

Push MULTI-CONTROL left or right to

adjust the brightness level.
Each time

MULTI-CONTROL is pushed left or

right, brightness level increases or decreases.
0 to 31 is displayed as the level is increased or
decreased.

# When dimmer is functioning, the brightness
level can be adjusted

0 to 21.

Correcting distorted sound

When listening to a CD or other source on
which the recording level is high, setting the
equalizer curve level to high may result in dis-
tortion. You can switch the digital attenuator
to low to reduce distortion.
! Sound quality is better at the high setting

so this setting is usually used.

1

Use MULTI-CONTROL to select

Digital ATT.
Digital ATT appears in the display.

2

Press MULTI-CONTROL to select the di-

gital attenuator level.
Pressing

MULTI-CONTROL repeatedly will

switch between

High (high) and Low (low)

and that status will be displayed.

Switching the sound
muting/attenuation

Sound from this system is muted or attenu-
ated automatically when the signal from the
equipment with mute function is received.
! The sound is muted or attenuated, MUTE

or

ATT are displayed and no audio adjust-

ment is possible.

! Sound from this system returns to normal

when the muting or attenuation is can-
celed.

Initial Settings

En

66

Section

14

Advertising