Sony STR-DA1800ES - Manuel (Page 20)

20 US
D:\NORM'S JOB\SONY HA\SO120031\STR-DA1800ES_PMRF
02\4428194122_USFR\US04GET_STR-DA1800ES-CEL.fm masterpage: Left
STR-DA1800ES
4-428-194-12(2)
The receiver is equipped with a function for converting video signals.
Video signals and component video signals can be output as HDMI video signals (HDMI OUT jack
only). As the default setting, video signals input from the connected equipment are output as shown
in the table with solid arrows.
: Same type of signal as that of the input signal is output (Main zone & Zone 2).
: Video signals are upconverted and output (up to 1080p) (Main zone).
Notes on converting video
signals
• When video signals from a VCR, etc., are up
converted on this receiver and then viewed
on your TV, depending on the status of the
video signal output, the image on the TV
screen may appear distorted horizontally or
no image can be seen.
• If you are using an image improvement
circuitry with your VCR, it may impact the
video signal conversion. It is recommended
to turn off this function on your VCR.
• Converted HDMI image output does not
support x.v.Color (x.v.Colour), Deep Color
(Deep Colour), 4K and 3D.
• HDMI video signals cannot be converted to
component video signals and video signals.
To connect a recording
equipment
When recording, connect the recording
equipment to the VIDEO OUT jacks of the
receiver. Connect cords for input and output
signals to the same type of jack, as VIDEO
OUT jacks do not have an up-conversion
function.
Note
Signals output from the HDMI OUT or MONITOR
OUT jacks may not be recorded properly.
Function for conversion of video signals
INPUT jack OUTPUT jack
HDMI IN
COMPONENT VIDEO IN
VIDEO IN
HDMI OUT
COMPONENT VIDEO MONITOR OUT
MONITOR VIDEO OUT