Sony STR-DA1800ES - Manuel (Page 132)

132 US
D:\NORM'S JOB\SONY HA\SO120031\STR-DA1800ES_PMRF
02\4428194122_USFR\US07ADD_STR-DA1800ES-CEL.fm masterpage: Left
STR-DA1800ES
4-428-194-12(2)
The remote control does not function.
• Point the remote control at the remote
control sensor on the receiver (page 10).
• Remove any obstacles in the path between
the remote control and the receiver.
• Replace all the batteries in the remote
control with new ones, if they are weak.
• Make sure you select the correct input on
the remote control.
• When you operate a programmed non-
Sony equipment, the remote control may
not function properly depending on the
model and the manufacturer of the
equipment.
If there is a malfunction, a message appears on
the display panel. You can check the condition
of the system by the message. If any problem
persists, consult your nearest Sony dealer.
PROTECTOR
Irregular current is output to the speakers, or
the receiver is covered and ventilation holes
are blocked. The receiver will automatically
turn off after a few seconds. Remove the
object covering the upper panel of the
receiver, check the speaker connection and
turn on the power again.
USB FAIL
An over current from the (USB) port was
detected. The receiver will automatically
turn off after a few seconds. Check the
iPod/iPhone or USB device, then unplug it
and turn on the power again.
For other messages, see “Message list after
Auto Calibration measurement” (page 48),
“iPod/iPhone message list” (page 58), “USB
message list” (page 61) and “Network features
message list” (page 82).
Reference sections
Refer to the following web site for details of
the latest information on the receiver.
For customers in the USA:
http://www.esupport.sony.com/
For customers in Canada:
[English]
http://www.sony.ca/ElectronicsSupport/
[French]
http://fr.sony.ca/ElectronicsSupport/
Remote control
Error messages
Clearing the memory
To clear See
All memorized settings page 42
Customized sound fields page 69
About support information