Harman Stove Company PC 45 - Manuel (Page 24)

24 PC 45 Corn/Pellet Stove
"Sunrise" Gold Trim
This kit includes a gold trim piece for the ash lip
and a gold Sunrise piece for the door. See Fig. 42.
Referring to the diagram, page 5, note how the
various components of the door system fit together.
Lay the load door face down on a soft surface.
Clean the glass thoroughly using a nonabra-
sive glass cleaner. Install the glass gasket around
the outer edge of the front face of the door glass
carefully to insure proper sealing.
Note: There are 4 tabs on the Sunrise. These
tabs have a step on the front side and are flush on
the back side. Place the "Sunrise" in the door so the
step side is to the front.
Set the glass pane gently onto the door. In-
stall the hold-down clips and tighten with bolts as
shown on page 5.
To install ash lip trim, simply slide the trim over
the ash lip and into the groove on the trim.
Gold Door
The gold door (fig. 43) is assembled and in-
stalled the same as the standard door. Refer to page
5. Be careful not to scratch the glass and be sure to
clean the gold before starting a fire in the stove.
To install ash lip trim, simply slide the trim over
the ash lip and into the groove on the trim.
Cleaning Gold
The gold plated door and gold Sunrise should
never be buffed or polished. Abrasive cleansers and
metal polishes will remove the plating and therefore
should never be used. If the gold needs to be
cleaned, wait until the stove is completely cool, then
use a sponge, soap and water to gently remove dirt
and stains. Before relighting the stove, remove all
soap residue and wipe dry.
Tabs
Tabs
Door Options
Fig. 42 Fig. 43