Complete installation checklist, Reverse door swing (optional) – Maytag MGDB755DW Installation Manuel d'utilisation

Page 22

Advertising
background image

22

COMPLETE INSTALLATION

CHECKLIST

q

Check that all parts are now installed. If there is an extra

part, go back through steps to see what was skipped.

q

Check that you have all of your tools.

q

Dispose of/recycle all packaging materials.

q

Check dryer’s final location. Be sure vent is not crushed

or kinked.

q

Check that dryer is level. See “Level Dryer.”

q

Remove film on console and any tape remaining on dryer.

q

Wipe dryer drum interior thoroughly with a damp cloth to

remove any dust.

q

Read “Dryer Use” in your “Use and Care Guide.”

q

Set the dryer on a full heat cycle (not an air cycle) for

20 minutes and start the dryer.

q

Be sure the water faucets are on.

q

Check for leaks around “Y” connector, faucet, and hoses.

q

If you live in a hard water area, use of a water softener is

recommended to control the buildup of scale through the

water system in the dryer. Over time, the buildup of lime

scale may clog different parts of the water system, which will

reduce product performance. Excessive scale buildup may

lead to the need for certain part replacement or repair.

If the dryer will not start, check the following:

Dryer is plugged into a grounded 3-prong outlet.

Electrical supply is connected.

Household fuse is intact and tight, or circuit breaker

has not tripped.

Dryer door is closed.

q

When the dryer has been running for 5 minutes, open the

dryer door and feel for heat. If you feel heat, cancel cycle

and close the door.

If you do not feel heat, turn the dryer off and check to see

whether gas supply line shut-off valve is open.

If the gas supply line shut-off valve is closed, open it,

then repeat the 5-minute test as outlined above.

If the gas supply line shut-off valve is open, contact a

qualified technician.

NOTE: You may notice an odor when the dryer is first heated.

This odor is common when the heating element is first used.

The odor will go away.

REVERSE DOOR SWING

(OPTIONAL)

NOTE: Magnetized screwdriver is helpful.

Place towel on top of dryer to avoid damaging the surface.

Place towel on dryer

1.

Remove bottom screws

2.

Open dryer door. Remove bottom screws from dryer cabinet

side of hinges. Loosen (do not remove) top screws from dryer

cabinet side of hinges.

Lift door until top screws in dryer cabinet are in large part of

hinge slot. Pull door forward off screws. Set door (handle side

up) on top of dryer. Remove top screws from dryer cabinet.

Lift door off top screws

3.

Advertising
Ce manuel est liée aux produits suivants: