Avery Dennison 1160 Monarch - Manuel (Page 6)

PRINT ADJUSTMENT
1 Characters should not print off either side of
the label. Incorrect print adjustment affects
where characters print and also affects how the
label feeds. Adjust in very small steps. Then print
a couple of labels to test the effect.
REMOVING LABELS
1 Tear label strip and carefully remove
label roll. 2 Tear backing paper and pull label strip out. 3 Squeeze and release trigger until
backing paper strip exits here.
Correct Setting
Insert coin into slot.
Push button in and turn
in direction shown.
If label prints like this: If label prints like this:
Insert coin into slot.
Push button in and turn
in direction shown.
n
Some labelers do not have a
print adjustment slot. These
labelers have fixed positioning
and cannot be adjusted.
Tear
Tear
Pull