Panasonic WV-CS554 - Manuel (Page 15)

1. Multiplexed Vertical Drive (VD2) (Highest)
2. Line-lock (LL)
3. Internal Sync (INT) (Lowest)
Note: The priority of automatic sync mode is the same as shown above.
(7) White Balance (WHITE BAL)
You can select one of two modes for white balance adjustment as follows:
• ATW (Auto Tracing White Balance)
In this mode, the color temperature is monitored continuously and thereby white balance is set auto­
matically. The color temperature range for the proper white balance is approximately 2 600 - 6 OOOK.
Proper white balance may not be obtained under the following conditions:
1. The color temperature is out of the 2 600 - 6 OOOK range.
2. When the scene contains mostly high color temperature (bluish) objects, such as a blue sky.
3. When the scene is dim.
In these cases, select the AWC mode.
• AWC (Automatic White Balance)
In this mode, accurate white balance is obtained within a color temperature range of approx. 2 300 -
10 OOOK. See page 41 for the setting.
(8) Motion Detector (MOTION DET)
The Motion Detector detects the motion in the scene by monitoring changes in the brightness level.
You can select the level of sensitivity for motion on the SET UP menu.
When the camera detects the motion it supplies the alarm signal to the external equipment and stops
at its position for the preset DWELL time. See page 42 for the setting.
(9) Auto Focus (AF MODE)
The camera adjusts the focus automatically to the best position by sensing sharpness in the center
area of the picture. S, M and L stand for the breadth of the sensing area: Small, Middle and Large.
See page 43 for details.
MANUAL S, M, L: Auto-focus is activated when the AF key on the controller is pressed.
AUTO S, M, L: Auto-focus is activated automatically while operating manually (WV-CS854A): pan, tilt
or zoom. Auto-focus is activated automatically after a manual operation (WV-CS554).
Note: If SENS UP is set to ON except x2 FIX or x2 AUTO setting, AUTO (S/M/L) is disabled and
MANUAL (S/M/L) is automatically selected.
(10) Special 2 Menu (SPECIAL 2) or Special Menu (SPECIAL) ««¿S«
This menu allows you to adjust the following items: chroma level, aperture level, pedestal level, chro­
ma phase (hue), and up side down. You can also reset your parameters to the values preset at the
factory. See page 44 for the setting.
• RS485 Communication utMb’
Communication parameters
• Full/Half duplex (page 51)
• Transmission speed (2 400 - 19 200 bps) (page 47)
• Parity bit. Stop bit. Flow control (page 47)
• Wait time, Delay time, Alarm output (page 47)
• Camera units (96 units max.) (page 49)
• Termination ON/OFF (page 51)
• Reset parameters (page 48)
15