Sony TCD-D8 - Manuel (Page 22)

Assigning Program Number
The program number is a j
signal which indicates
the number of the
program (track).
The program number is
written at the same time
as the Start ID.
Note
Writing and renumbering
of the program number
may not be completed
successfully to the tape
that has been recorcied on
another DAT deck and
has a Start ID at the
beginning.
When recording from the beginning of the tape
The program number is written automatically from
number 1 in sec]uential order at the same time as the
Start ID.
When recording from the halfway of the tape
Press the ►►/►►I or button to display the
program number before you begin recording. The
program number is written in sequential order from
the following program at the same time the Start ID is
written.
Renumbering the program number
With the optional system adaptor kit RM-D3K or the
wired remote control RMT-D7, you can renumber the
program number. (For more details, refer to the
Operating Instructions manual that comes with each
product.)
" Pt tiur:" flashes while the
program number is
renumbered. When the
renumbering operation is completed, the tape-corder
rewinds the tape to the beginning and enters the stop
mode.
Renumbering is necessary to the following tape:
• On which the Start ID is written during playback.
• Which has missing program numbers or duplicated
program numbers because the tape is recorded from
the halfway c^f it.
• Which has a missing program number because the
program number is erased at the same time a Start
ID is erased on the tape.
IT Recording