Sony MDS-JB930 - Manuel (Page 47)

Make sure to change the deck to standby status
within a week after timer recording is
completed.
The TOC on the MD is updated and recorded contents are
written to the MD when you turn on the deck. If the
recorded contents have disappeared, "Initialize" flashes
when you turn on the deck.
Notes
• It may take about 30 seconds after the deck is turned on until
recording starts. When recording at a specified time using the
timer, be sure to take this time into account when setting the
recording start time.
• During timer recording, new material is recorded from the end
of the recorded portion on the MD.
• Material recorded during timer recording will be sa\ ed to the
disc the next time you turn on the deck. "TOC Writing" will
flash in the display at that time. Do not disconnect the AC
power cord or move the deck while the indication flashes.
• Timer recording will stop if the disc becomes full.
This deck is equipped with the V.C. (Variable Coefficient)
filters to allow you to adjust the tone to match your audio
system, listening environment, and the source being
played. Note that the digital filters are effective only on
the analog signals output from the LINE (ANALOG) OUT
jacks and the PHONES jack.
FILTER
Playing With Different
Tones (Digital Filter)
1 Press FILTER.
The currently selected filter appears in the display.
2 Press FILTER repeatedly to select the filter you
want.
Select To produce
Standard An expansive sound of wide range.
(factory setting)
Plain A fresh and powerful sound.
Analog A resonant and mellow sound.
The FILTER button lights green when a setting other
than "Standard" is selected in DF (digital filter)
display.
S’ You canjuse the remote to select the filter iH
Press FILTER repeatedly until the filter you want appears in the
display.
3-
(D
C
3
n
r*
o'
3
l/l
4 7 ^