Tweco 7-3474 - Manuel (Page 2)

Date: October 1, 2004 / 1 Octobre, 2004 2 Manual / Manuel 0-2954
B. Installation
1. Align the male connector on the ATC Remote Interface Adapter with the ATC female receptacle. Press the connector
into the receptacle. The connectors should push together with a small amount of pressure. Secure the connection
by turning the locking nut clockwise until it stops. DO NOT use the locking nut to pull the connection together.
2. Align the male connector on the torch leads (or torch leads extension) with the female receptacle on the Adapter Kit.
Press the connector into the receptacle. The connectors should push together with a small amount of pressure.
Secure the connection by turning the locking nut clockwise until it stops. DO NOT use the locking nut to pull the
connection together.
3. This kit includes an Adapter Connector which may be used to connect the Adapter Assembly to any remote control
device.
From Power Supply
To Torch
To Other Remote
Control Device
Art # A-03453
Adapter Connector
To Thermal Dynamics Remote Control Device
Switch
To Alternate Remote Control Device
Black
White
4. Reconnect input power to the Power Supply and turn ON the unit. The remote control device will now provide
on / off signals to the torch. Any other torch control switches will be inoperable with this Adapter Assembly in
place. To make other control switches operable, remove the Adapter Assembly.
5. The system is ready for operation, see WARNING.
WARNING
Turn OFF the power supply when connecting or disconnecting the ATC connections.
NOTE
Every effort has been made to provide complete and accurate information in this manual. However, the
publisher does not assume and hereby disclaims any liability to any party for any loss or damage caused by
errors or omissions in this Manual, whether such errors result from negligence, accident, or any other cause.