Tweco 7-3464 - Manuel (Page 2)

April 26, 2004 / 26 Avril, 2004 2 Manual 0-4631
B. Installation
1. Securely connect the two Control Wire Connectors provided in this kit to the torch control terminals on the
Power Supply torch connection panel.
2. Re - connect the two torch leads or adapter kit mating connectors disconnected previously. Slide the insulating
sleeve removed previously onto these two leads. Ensure that the sleeve covers and the mating connectors
completely. Secure the sleeve in place with a tie wrap provided in this kit.
3. Thread the smaller end of the gas fitting from this adapter kit onto the power supply torch connector. Tighten
securely. Do not use sealant.
4. Connect the negative / plasma lead fitting (on the torch leads or ATC Adapter) to the gas fitting previously
installed on the Power Supply. Tighten securely. Do not use sealant.
Tie Wraps
Bottom Flange
Torch Leads
Assembly
ATC Adapter Kit
Through-Hole
Protector
Securing Nut
Through-Hole
Protector Dome Nut
Through-Hole
Protector Assembly
Torch Leads
or
ATC Adapter Kit Leads
Torch Adapter
Connection Cover
Torch Control
Terminals
Control Wire
Connectors (2)
Art # A-03941
Power Supply
Connection Panel
Mounting Hardware
Or
Torch
Connector
Adapter
Fitting
Pilot Lead
Torch Control
Wires
Negative/Plasma
Lead Fitting
Insulating
Sleeves