Tweco 9-8421 - Manuel (Page 2)

April 24, 2003 / 24 Avril, 2003 2 Manual / Manuel 0-2931
B. Long Trigger Guard Installation
Install the Long Trigger Guard as follows:
1. Refer to the illustration. Remove the screws located
at the lower front and back ends of the Torch Handle.
Discard these screws.
2. Place the Trigger Guard onto the Torch Handle.
3. Secure the Trigger Guard to the Torch Handle using
the screws and acorn nuts provided in this kit. Tighten
the hardware securely.
WARNING
Do not hang the torch by the Guard.
A-03629
Left Side of
Torch Handle
Long Trigger
Guard
Remove lower
front screws
Acorn Nut
Remove lower
rear screws
Acorn Nut
Long Screw
Long Screw
Long Trigger Guard Installation
NOTE
Every effort has been made to provide com-
plete and accurate information in this manual.
However, the publisher does not assume and
hereby disclaims any liability to any party for
any loss or damage caused by errors or omis-
sions in this Manual, whether such errors re-
sult from negligence, accident, or any other
cause.