Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module Manuel d'utilisation
Page 6
Advertising
6 XM-124 Standard Dynamic Measurement Module
Rockwell Automation Publication 1440-IN001B-EN-P - October 2013
1. Position the terminal base unit on the 35 x 7.5 mm DIN rail (A).
2. Slide the terminal base unit over, leaving room for the side
connector (B).
3. Rotate the terminal base unit onto the DIN rail with the top of the rail
hooked under the lip on the rear of the terminal base unit.
31887-M
B
A
A
31883-M
Advertising