Rockwell Automation 1440-SDM02-01RA XM-124 Standard Dynamic Measurement Module - Manuel (Page 17)

XM-124 Standard Dynamic Measurement Module 17
Rockwell Automation Publication 1440-IN001B-EN-P - October 2013
DeviceNet Mode, Communication Rate, and Address
Under the slide at the top of the module is a 10-position DIP switch that is used
for setting the modules’ DeviceNet behavior, node address, and communication
rate. The switches are numbered from left to right and are applied as shown in
the illustration below and in the following table.
DIP Switch Bank
ATTENTION: The DNet V+ and DNet V- terminals are inputs to the XM
module. Do not attempt to pass DeviceNet power through the XM terminal
base unit to other non-XM equipment by connecting to these terminals.
Failure to comply can result in damage to the XM terminal base unit and/or
other equipment.
IMPORTANT
I
Terminate the DeviceNet network and adhere to the requirements and
instructions in the ODVA Planning and Installation Manual - DeviceNet Cable Sys-
tem, which is available on the ODVA website
http://www.odva.org .