Aquascape UltraKlear UV Clarifier (95036, 95037 & 95038) Manuel d'utilisation
Page 5
Optional Inlet/Outlet
Pond Water IN
Treated Water OUT
NOTe: Do not use tools
to attach the fittings.
5
www.aquascapeinc.com |
☎
CAN 1-866-766-3426 |
☎
US 1-866-877-6637
• an optional 2-way flow
control Valve (#88005) can
be used to make sure the
water flow does not exceed
the ultraKlear
®
Maximum flow
rate. please refer to the ultraKlear
®
specification chart included in
this manual for maximum flow rate
recommendations.
• aquaforce
®
solids-Handling
waterfall pump is ideal for use with
the ultraKlear
®
– the aquaforce
®
pre-filter cage allows
for the pump to be
submerged directly in
the pond and improves
uV efficiency by
pre-filtering the larger
debris from reaching
the ultraKlear
®
. other
in-pond pump makes
and models can also
be used.
• the ultraKlear
®
is designed to be located outside the
pond. we recommend placing it in a location that is easy
to hide and access for maintenance. the ultraKlear
®
can be attached to a board and set on level ground or
mounted using the four screw holes in the support saddles
as shown here.
• the ultraKlear
®
includes three plumbing ports:
- in – pipe from pump (can use either end port
as pond water “in”).
- out – pipe back to pond (use opposite end
port for discharge back to pond).
- optional inlet/outlet to assist with installation
and pipe routing.
AquaForce
®
Pond Pump
2-Way Flow Control Valve
UltraKlear
®
with Rotational Ball
fittings and Multi-Hose Adapters
Multi-Hose Adapters mounted
directly to UltraKlear
®
Rotational Ball fittings
• the 90º elbow fittings and locking rotational ball fittings
allow 360º directional movement to accommodate the
plumbing configuration desired or the Multi-Hose adapters
can be mounted directly onto the ultraKlear
®
fixture as
shown below.
• fittings should be hand-
tightened only and be
installed with the flat
rubber gaskets to achieve
leak-free seals.
95085 UltraKlear UV Clarifier Instructions FINAL 12-13.indd 5
12/12/13 4:39 PM