Aquascape AquaBasin 3-Piece Plumbing Kit (98410) - Manuel

Installation Instructions
Item # 98410
IDD 08016039-ADI 070543
Package Includes:
• Plumbing AquaBasin ™ 4 way FPT Splitter (1)
• Fitting Elbow ¾” MPT x ¾” Barb (2)
• Plumbing ¾” Barbed Ball Valve (2)
• Fitting Barbed 90 Degree Elbow ¾” (2)
• Fitting
9 /
16
” to 1 ¼” Hose Clamp (9)
• Pipe Kink Free ¾” x 6’ Cut (2)
• Fitting Barbed Male Hose Adap ¾” x ¾” (1)
AquaBasin
™
Plumbing Kit
Made in U.S.A. for
Aquascape, Inc.
St. Charles, IL 60174 • Brampton, ON L6T 5V7
www.aquascapeinc.com ©2008 Aquascape, Inc. • All Worldwide Rights Reserved
REPLACEMENT PARTS
To order replacement parts, contact your local Aquascape™ retailer.
Replacement Part Item #
Plumbing AquaBasin™ 4 way FPT Splitter 98412
Fitting Elbow ¾” MPT x ¾” Barb 98411
Plumbing ¾” Barbed Ball Valve 98148
Fitting Barbed 90 Degree Elbow ¾” 99185
Fitting 9 /
16
” to 1¼” Hose Clamp 98149
Fitting Barbed Male Hose Adap ¾” x ¾” 99153
Troubleshooting
Water is coming out the bottom but not out the top?
Make sure tubing is as close to the top of decorative
piece as possible. If water still continues to run down
center hole, try using silicone or foam (not included)
and place around tubing inside the center hole. This
will prevent the water from running down the center.
Too much/little water is coming out?
Adjustment of ball valve may be necessary.
Adjust ball valve to desired water flow.
Installation
1) Attach 4 way FPT splitter to threaded adapter
on pump. (Threaded adapter included in
AquaBasin ™ Pump Kit 1500).
2) Screw the one ¾” MPT x ¾” Barb elbow on the
left and right end of the splitter. Screw the
¾” x ¾” barbed male hose adapter on the top
end of the splitter.
3) Cut a 2” section of tubing and place over end of
each barbed adapter and secure with hose clamp.
4) Place ball valve over each section of tubing
and secure with hose clamp.
5) Taking each section of 6’ tubing from kit, one
section will be included from AquaBasin ™ pump
kit 1500, and put on opposite end of ball valve
and secure with hose clamps.
6) Run tubing to each decorative piece, cut tubing at
base of decorative piece and place 90 degree elbow
on each end of tubing securing with hose clamp.
7) Take left over section of each tubing and place on
opposite end of 90 degree elbow and secure with
hose clamp. Run tubing to and through the end
of decorative piece and cut off any excess tubing.
Also Consider...
150 Watt Transformer 10 Watt Waterfall Light LED Core Ring Light LED Bullet Spotlight Feature Algae Free ™ / Foam Free ™ / Scale Free ™