Aquascape AquaRock (97068) Manuel d'utilisation

Aquarock, Fountain kit, Installation instructions

Advertising
background image

AquaRock

Fountain Kit

Step 1.

Find a suitable location.

Look for a location where your new water
feature can be easily seen and enjoyed, near to
an existing patio or deck or walkway and ideally
where it can be seen from inside your home.
Keep in mind you’ll need an electrical outlet
nearby to power the water pump. Unpack the
contents of your new water feature.

Step 2.

Clear an area the size of the circular

plastic liner that came with your kit.

Step 3.

Dig a hole two inches deeper than

the bucket. It should be deep enough so the
surrounding dirt can be sloped toward the
bucket to allow the water to flow back to the
water pump.

Step 4.

Place the pump in the bucket with

the hose attached to the pump.

Step 5.

Center the liner over the bucket.

Feed the power cord through the 1 ¼” hole in
the lid and feed the hose through the center
of the lid. Snap the lid onto the bucket with
the liner between the lid and the bucket.

Step 6.

Cover the liner and lid with an inch

or two of decorative gravel (not supplied). Make
sure the liner is laying flat against the soil so
that you can completely cover and camouflage
the liner.

Step 7.

Insert the hose through the stack of

rocks and adjust the depth of gravel under the
rocks so the hose does not stick out above the
top rock.

Step 8.

Fill the underground bucket by

pouring water directly onto the rocks. Once
you see water coming up through the gravel
the underground bucket is full.

Step 9.

Plug the pump into the electrical

outlet and enjoy your new fountain. You may
adjust the flow of water off the rocks by
tilting the rocks one direction or another. Each
stacked rock can also be spun individually to
achieve just the right effect and appearance.

Note:

You may run an irrigation drip line

into the underground bucket so that it fills
when your irrigation timer is engaged. This
is especially helpful in dry, desert climates.
Sprinklers and rain water are also very
helpful to fill the underground bucket and
reduce maintenance.

AtteNtioN:

if your new Fountain kit

will be used in colder climates the water pump
will need to be stored inside for the winter.
the bucket can be left outside but should
be drained and covered.

For more information about our company
or products please visit our website at
www.aquascapeinc.com or call (US)
1-866-877-6637 (CAN) 1-866-766-3426

CAUtioN:

Make sure to check for any

buried utility lines such as telephone or cable
TV before digging.

Note:

You will need to gather the following

tools or supplies:
• Shovel or Spade
• Wheel barrow or bucket for excess dirt
• Decorative rocks to hide the lid of your

kit as well as the liner skirt

InstallatIon InstructIons

w w w. a q u a s c a p e i n c . c o m • 1 . 8 6 6 . 8 7 7 . 6 6 3 7

Item #97115 • SMD 10037899-AI 100045

©2010 Aquascape, Inc.

Made in U.S.A. • All Worldwide Rights Reserved

Advertising
Ce manuel est liée aux produits suivants: