Pioneer VSX-C502-S - Manuel (Page 23)

Controls and displays
23
En
English
04
SURROUND (page 27)
Use to select a SURROUND mode for the current
source.
ADVANCED SURROUND (page 28)
Use to select an ADVANCED SURROUND mode for
the current source.
SOUND MODE (page 28)
Use to select a SOUND MODE for the current
source.
DIALOG (page 28)
Press to switch on/off DIALOG (dialog
enhancement).
10 MUTE
Press to mute all output. Press again (or adjust the
volume using the
MASTER VOLUME control) to restore
the sound.
11 SBch MODE (page 29)
Use to select the surround back channel mode and
virtual surround back options.
12 MASTER VOLUME
Use to adjust the volume.
13 MCACC SETUP (page 24)
Press to start MCACC (Multichannel Acoustic
Calibration) setup.
14 SYSTEM SETUP (page 36)
Press to access the SYSTEM SETUP menu to make
detailed receiver settings.
15 Cursor keys and ENTER
Use to navigate menus and select options/execute
commands.
16 CH SELECT (page 40)
First press RECEIVER , then press CH SELECT repeatedly
to select a speaker channel to adjust.
17 TEST TONE (page 40)
First press RECEIVER , then press TEST TONE to start/
stop the test tone.
18 Playback controls (page 43)
Playback controls for external components, such as DVD
and CD players.
Functions printed in blue control the built-in tuner; other
functions control other external equipment.
19 Number buttons (page 43)
Use for numerical input of track numbers, radio
frequencies, and so on.
20 CHANNEL +/– (page 43)
Use to change channels on a satellite receiver, cable box,
VCR or DVR.
21 DIMMER
First press RECEIVER , then press DIMMER repeatedly to
change the brightness/switch off the front panel display.
The display will light brightly for about two seconds when
you operate the receiver with the display off or dimmed.
(Note that the master volume indicator always remains
lit, even when the rest of the display is off.)
22 TV CONTROL buttons (page 41)
Use to control your TV (after setting up the remote control
to work with your TV).
23 SLEEP (page 34)
First press RECEIVER , then press SLEEP repeatedly to put
the receiver into sleep mode and select the length of time
before the receiver turns off.
Operating range of the remote control
The remote control may not work properly if:
• There are obstacles between the remote control and
the receiver's remote sensor.
• Direct sunlight or fluorescent light is shining onto the
remote sensor.
• The receiver is located near a device that is emitting
infrared rays.
• The receiver is operated simultaneously with another
infrared remote control unit.
30
30
7m
vsx-c501(WY).book 23 ページ ２００４年４月２３日 金曜日 午後２時５６分