Magikitch'n MCF18 - Manuel (Page 9)

INSTALLATION/OPERATION
7
Initial Adjustments
After your appliance has been properly installed as described in the installation section of this manual, it will
need to be adjusted to ensure that it will perform as designed. These adjustments must be performed by a
qualified person. To perform these adjustments the following tools will be needed:
• Manometer
• Digital Thermometer (Temperature Probe)
• DC Millivolt Meter
Before you begin filling and adjusting the appliance, perform the
following visual checks:
a. After the appliance is in its permanent location,
check the levelness. Any additional leveling that
is necessary can be performed as previously
described.
b.
Check the temperature probe and high limit bulb
(in the tank) to ensure that the mounting screws
are tight.
c. Review the installation portion of this manual and
ensure that all steps have been followed and
executed properly.
Burner Ignition Systems
CAUTION
Before proceeding any further, fill the tank with WATER. Water is used for the installation
adjustments because the temperature will never exceed 212°F (100°C), thereby allowing
plenty of adjustment time. Never let the water level go below the “OIL LEVEL” mark
stamped on the tank.
Ensure that these
Parts are not loose