Sony CMT-MD1 - Manuel (Page 21)

21
Basic Operations
5
Press REC.
The MD stands by for recording and the
REC indicator lights up red.
6
Press MD ^ (or MD ( or MD P
on the remote).
Recording starts.
To stop recording
Press MD p.
To record non-preset radio
stations
To record non-preset stations, press
TUNING MODE on the remote repeatedly
until “MANUAL” appears in step 3, then
press TUNING + or – to tune in the desired
station.
Tip
If noise is heard while recording an AM radio
station, reorient the AM loop antenna to reduce the
noise.
While “TOC” is lit or is flashing
To ensure complete recording, do not move
the system or disconnect the power cord. The
system updates the Table of Contents (TOC)
while “TOC” is flashing.
Notes
• The MD recording is complete only after all the
recording information is entered to TOC at which
point TOC stops flashing and goes out. Be careful
not to disconnect the power cord or move the
system before this point. Before disconnecting the
power cord, do the following:
– Remove the MD.
– Press
1/u to turn off the system.
• If the MD is record protected, “MD Protected”
appears in the display and the MD cannot be
recorded on. Press MD
6 and remove the MD,
slide the record protection tab to the closed
position (see page 30), reinsert the MD and try
again.
• Please do not use MDs with labels that are
protruding or labels that have not been positioned
correctly. Use of such MDs may damage this
system.