Sony STR-DA5200ES - Manuel (Page 34)

34 GB
Notes on converting video signals
• When video or S video signals from a VCR,
etc., are converted on this receiver and then
output to your TV, depending on the status of
the video signal output, the image on the TV
screen may appear distorted horizontally or
no image may be output.
• HDMI video signals cannot be converted to
component video signals, S video signal and
video signals.
• The converted video signals are output only
from the MONITOR OUT jacks. They are
not output from VIDEO OUT jacks, S
VIDEO OUT jacks, or the ZONE 2 VIDEO
OUT jack.
• When you play a VCR with an image
improvement circuit, such as TBC, the
images may be distorted or may not be
output. In this case, set the image
improvement circuit function to off.
• The resolution of the signals output to the
COMPONENT VIDEO MONITOR OUT
jacks is converted up to 1080i. The
resolution of the signals output to the HDMI
OUT jacks is converted up to 1080p.
• COMPONENT VIDEO MONITOR OUT
jacks have restrictions on resolution when
the resolution of video signals protected by
copyright technology is converted.
Resolution of up to 480p can be output to the
COMPONENT VIDEO MONITOR OUT
jacks. The HDMI OUT jacks have no
restriction on resolution.
• Video signals for which the resolution has
been converted cannot be output from either
the COMPONENT VIDEO MONITOR
OUT jacks or the HDMI OUT jacks.
Connect to the VIDEO/S VIDEO/
COMPONENT VIDEO MONITOR OUT or
HDMI OUT jack, whichever you prefer. The
video signals are output from the HDMI
OUT jack when both are connected.
Set “Video Convert” to OFF in the Video
settings menu to output the video signals
from the VIDEO/S VIDEO/COMPONENT
VIDEO MONITOR OUT jack when both
are connected.
Closed Caption display
Set “Video Convert” to “OFF” in the Video
settings menu when receiving a signal that
supports Closed Captions. If “Video Convert”
is set to on, you cannot display Closed
Captions.
To connect a recording
component
When recording, connect the recording
component to the VIDEO OUT jacks or S
VIDEO OUT jacks of the receiver. Connect
cords for input and output signals to the same
type of jack, as VIDEO OUT jacks and S
VIDEO OUT jacks do not have an up-
conversion function.
Note
Signals output from the MONITOR OUT jacks may
not be recorded properly.