Sony STR-DA5200ES - Manuel (Page 114)

114 GB
2
Press ZONE 2 or ZONE 3.
The remote switches to zone 2 mode or
zone 3.
3
Turn on the amplifier in zone 2
or zone 3.
4
Press one of the input buttons
on the remote to select the
source signals you want to
output.
For zone 2, analog video and audio
signals are output. For the zone 3, only
analog audio signals are output. When
you select “SOURCE,” the signals of the
current input are output.
5
Adjust to a suitable volume.
• In the case of illustration 1-1 or 2
(page 104), you can only adjust the
surround back speaker volume in zone 2
or zone 3.
1 Set “Sur Back Assign” to “ZONE 2”
in the Auto Calibration settings
menu (page 73).
2 Adjust the volume using MASTER
VOL +/– on the remote.
• In the case of illustration 1-2
(page 104), adjust the volume using the
receiver of zone 2.
Tips
• Even when this receiver is standby mode (press ?/
1 on the remote to turned off this receiver), the
receiver in zone 2 or zone 3 remains turned on. To
turn off all receivers, press ?/1 and AV ?/1 on the
RM-AAL005 remote at the same time (SYSTEM
STANDBY).
• Only signals from components connected to the
analog input jacks are output through the ZONE 2
or ZONE 3 jacks. No signals are output from
components connected to only the digital input
jacks.
• When “SOURCE” is selected, the signals input to
the MULTI CHANNEL INPUT jacks are not
output from the ZONE 2 OUT or ZONE 3 OUT
jacks even when MULTI IN is selected. The analog
audio signals of the current function are output.